Topic: my setting

[craziechild]

TW = HP: 3.5kHz @ 12db @ level 0db
MID = HP: 80Hz @ 12db ; LP: 3kHz @ 12db @ level 0db
LOW = LP 63Hz @ 12db @ level 0db
phase 0 for all drivers...

this is always my initial setting...
from here do the followings:
1. gain settings, set your gain so that there is no driver that over-powering the other driver... either at the amp, or the level in the xover, whichever sounds best to you...
ie. TW is louder than the MID, the you decrease the TW gain, increase the MID gain.
2. tweeter angling/placing... find the spot to mount where the staging is at your prefered level... i prefer eye level...
3. staging in on one side of the stage, try reversed polarity on one of the driver... sometimes it works, sometimes it doesnt...

i think thats all for now... need to know the result from all these then i could continue... hehehe... too many posibilities after this one... haha...

[myvi3923]

Sifu, if i using passive xover from the comp set. What is the recommended general xover setting suppose for my HU.
My current setting:
Hi - Pass
LP - 200hz @ 12db 
HP - 80hz @ 12db
Sub LP - 100hz @ 12db (10" sub)

If u figure out anything wrong with my current setting please enlighten me. TQ!

[montero]

wait ya craziechild...
i'll give the result..
maybe now i just want to stay with 2 way coz dun want to pening2 lagi about apparatus.
 O0

[Zenn]

i suggest u start at:

sub lp 63, slope 12db, or can go 80, or can go 50 at 18 or 24 also, try-2 la
mid hp 63 slope 12, can try 50 at 18 or 24
mid lp 2k or 2.5k at 12, or 18, or even 6, try-2 la....
tweeter hp 2k at 12db, ive even tried rs pro tweet at 1.5k no problem, full range also can, hahaha....but play around la, maybe 2.5k at 18db

keep playing around, thats part of the fun, u will educate yourself about tuning...